![]() ![]() This can create problems in some situations. Josh More, in UTM Security with Fortinet, 2013 Specifying the Source IP Address for FortiOS Originated TrafficĪ FortiGate has many interfaces and, therefore, can have many source IP addresses. This configuration makes Router 3.3.3.3 a virtual ABR, so you would enable authentication for area 0 on Router 3.3.3.3. The images show that Router 3.3.3.3 does not have an interface in area 0 but connects virtually to area 0. 6.Īnd finally type in area 0 authentication and then press the Enter key.įigure 7.3 displays the interface configuration for Router 1.1.1.1 and Figure 7.4 displays the interface configuration for Router 3.3.3.3. Next input the networks to run OSPF by typing 192.168.1.0 0.255.255.255 area 0 and then press the Enter key. Loopback interface password#To configure area 0 for plain text password authentication type router ospf 2 and then press the Enter key. To enable OSPF authentication on this interface type ip ospf authentication-key Syngress. 2.Īt the (config) prompt type interface Ethernet0 and press the Enter key on your keyboard. ![]() Log on to your router and enter global config mode. Follow these steps to enable and configure plain text authentication. The second part of this exercise will have you enable OSPF plain text authentication. 4.Īt the (config-router) prompt type end and press the Enter key. 2.Īt the (config) prompt type interface loopback 0 and press the Enter key on your keyboard. Log on to your router and enter the global config mode. Follow these steps to enable and configure the loopback interface. The first step will be to configure loopback interface 0 on your router. In this exercise, we will perform two configuration steps. EXERCISE 7.1 Configuration of the Loopback Interface and OSPF Authentication ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |